A few tips on beam cutting press operation

Machine picture-Hydraulic precision four column cutting machine. - 副本.jpg                                                       

Beam cutting press is another hot sale machine type. Its widely choosed by our end users. For the safe and correct operation, here we would like share below tips:


1. Keep the cutting die in the middle position of the top plate and keep the machine getting average pressure.Must make sure the cutting table in the same height position.

2.If possible, we advice lubricate the junction of four-columns and bushing twice every working day ,that make sure the columns running smoothly.

3.When the cutting machine working, the operator’s body should not keep too close to the upper press board to prevent dangerous.

4.If the operator need leave the working position temporarily, please turn off the power to avoid another person make incorrect operation and cause damage on the machine.

5.Please press the both botton at the same time,once press head down to required postion,release one of the botton ,the press head will move back.

6.When operate this beam cutting press,must use both two hands ,prohibits the hand into the cutting area.

7.If the worker meet any problem ,please contact Zhicheng machinery. We will give reponse within 24 hours.